Ends Per Minute - 200 - 404D Up to 200 EPM
404 - 603D Up to 160 EPM
603 - 714D Up to 120 EPM
Сравнительные характиристики:
Марка
S-B9B
Range of End Dia.
4 H
Irregular ends
Up to 200 EPM
Ends Per Minute
200 - 404D Up to 200 EPM
404 - 603D Up to 160 EPM
603 - 714D Up to 120 EPM
Horse Power Required
3HP, 2HP, 1HP, 1/4HP EA
Range of Strip Length
510 - 915mm
Range of Strip Width
64 - 220mm
Max. Die Height
250mm
Floor Space Overall Height
3050 x 2980 x 1865 mm
Net Weight (approx.)
4800 kgs
Описание:
Automatic Strip Feed Press is built for can end or battery
jacket stamping. Piled strips are lifted by a set of hydraulic cylinders
then suck pads send strip one by one to strip feeding station. (also can
link with Automatic Strip Feeder S-B18-2M). Reciprocating feeding bar at
feeding station push strip into punch tooling. Formed can end (or battery
jacket) is ejected out via. an end kicker(or air blowing) to rear while strip
scrap is ejected out by a pressing roller to side. Punch tooling is made of
alloy steel; hence, sturdy for long life. An automatic lubrication pump and
multiple safety devices are equipped for easy maintenance and safe operation.
Особенности:
Strips lifting by hydraulic cylinder and use proximity switch for strips height control.
With duplex switch for machine starting, safe and reliable.
With Air Clutch for power transmission, effective but low maintenance.
Multi-safety design for machine and personnel safety.
Easy for can size changeover and adjust.
Can be connected with automatic strip feeder model S-B18-2M to save labor cost.
Double sheet detector is equipped for safe strip feeding.
Formed ends are ejected by air blowing or mechanical kicker.
Battery jacket punch is possible. Coil feeding system is introduced for this purpose.
